Chapter 2 Provisioning
Step by Step Installation and Initial Configuration
Before proceeding, you must refer to the “Caveats” section in the Release Notes for Cisco Packet Telephony Center, Release 2.1 to see whether you must modify any of the parameters in the /etc/system file. After the following the instructions in the “Caveats” section: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/ptc/2_1/relnotes/relnote.htm#65500.
Assuming compliance, proceed.
Step 19 Reboot the Cisco PTC machine.
You must reboot the Cisco PTC Server machine at this time, no matter if this is an initial installation or reinstallation of Cisco PTC, or the parameters in the /etc/system file were modified.
Step 20 Upon rebooting the Cisco PTC machine, proceed to the next section (“Installing the Cisco CNS Integration Bus and Cisco CNS Security Packages” ).
Installing the Cisco CNS Integration Bus and Cisco CNS Security Packages
This section describes how to install the CNS INTEGRATION BUS and CNS SECURITY packages once you have successfully installed the Cisco PTC CNSC
Step 1 Open an Xwindow session and log in as user root:
Step 2 Set the DISPLAY environment variable to the IP address of the machine you are using (assuming C shell):
Step 3 Invoke the Cisco PTC installation script from the product directory:
ptc-tme# ./cnscInstall
Step 4 Observe the Cisco PTC Installation window again, as shown in Figure
Step 5 Click the CNS INTEGRATION BUS check box. Only the CNS INTEGRATION BUS check box should be selected at this time.
Step 6 Enter the same information as you did for the CORE installation.
Step 7 Upon successful completion of the installation process, deselect the CNS INTEGRATION BUS package and then select the CNS SECURITY package by clicking on their respective check boxes. Only the CNS SECURITY check box should be selected at this time.
Step 8 Enter Input parameters again for the CNS SECURITY package.
Step 9 Upon successful completion of the CNS SECURITY package's installation process, click the Exit button.
The Cisco PTC Installation window is closed.
Step 10 Verify the CNS INTEGRATION BUS package installation was successful by invoking the following command:
ptc-tme# pkginfo -l TIBRV
PKGINST: TIBRV
NAME: TIB(r)/Rendezvous(tm) Software V6
CATEGORY: application
ARCH: sparc
VERSION: 6_4
BASEDIR: /opt/cisco/vnm/common/tibrv
Cisco Internet OSS for VoIP: Infrastructure Manager Implementation Guide
|
| |
|