Cable schematic, S8300/G700 Configurations, MM710 RJ45

Software:

1.Recommended Siemens Hicom 300. Release 9006.5 or newer.

2.Firmware for the boards and phones are included in the core software.

Hardware:

1.TNBN64P and TNDN64 can be programmed to run PRI and NI2.

2.TMDN TMD24 can only be used with PRI.

Board type used is dependant on software and hardware release of the switch.

4. Cable schematic:

Note: A length of 4-wire cable is needed to make the connection to each PRI circuit card. The Pin assignments for each are as follows.

Siemens TMDN64P (25 pair amphenol)

XTIP	pin 16	RTIP	pin 13
XRING	pin 41 RRING		pin 38
MM710 (RJ45)
XTIP	pin 4	RTIP	pin 1
XRING	pin 5	RRING	pin 2

TN464 DS1 (wall field)

XTIP	pin 22 RTIP	pin 23
XRING	pin 47 RRING	pin 48

5. S8300/G700 Configurations:

The following pages are excerpts of an actual system administration session using the Avaya VisAbility™ Software Suite.

DS1 Interface: ISDN maximizes the number of connections between the switches due to the fast processing of calls across that medium. ISDN also allows for Caller ID, Call Tracing, Call Return and many other features. Configure the DS1 form as described below. Select “isdn- pri” for the Signaling Mode, this allows for Facility and Non-facility Associated Signaling. Select “b8zs” for the line coding which is required when running ISDN. Framing Mode should be “ESF” to allow for best signaling quality. Setting the Connect and Interface prompts to “PBX” and “Network” allows the MM710 to have control over glare conditions. This allows the MM710 to have priority over circuit assignment and force the switch on the other end to continue searching for an open B-Channel. All other prompts are default. If using NI-2 (National ISDN–2) change Protocol Version to “b”.

Jsl	© 2002 Avaya Inc All Rights Reserved	IP Enabling Siemens
		Hicom with Avaya
		MultiVantage Solutions
LPH 11-27-02		4