6.Check each place listed (A
7.Turn OFF gas supply at cylinder valve.
8.Turn on control knob to release gas pressure in hose.
9.Turn control knobs to “off” position.
10.Tighten any leaking connections.
11.Repeat soapy water test until no leaks are detected. DO NOT use the grill if leaks cannot be stopped. Contact a qualified gas appliance repair service.
12.Turn OFF gas supply at cylinder valve until you are ready to use your grill.
13.Wash off soapy residue with cold water and towel dry.
14.Wait 5 minutes to allow all gas to evacuate the area before lighting grill.
NOTE: The leak test must be performed in an area that has adequate lighting in order to see if bubbles are developing. DO NOT use a flashlight to check for bubbles.
WARNING
PRE-START CHECK LIST:
Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps should be performed after the grill has been assembled, stored, moved, cleaned, or repaired. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual.
•Insure that the grill is properly assembled.
•Check burner venturi tube for blockage from insect nests. See section on "Cleaning and Maintenance".
•Check that burner venturi are seated properly over the valve outlet as shown
in the assembly instructions. The orifice must be inside the burner venturi for proper air/fuel mixing.
•Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. Hoses should be at least 3 inches from hot surfaces.
•Leak check all gas connections and hoses. See section on "Leak Testing".
•Ensure that all electrical supply cords are properly grounded and are kept away from water and hot surfaces.
•Position your grill on level ground in a well ventilated location, a safe distance from combustible materials and buildings.
•Properly place an empty grease collection cup under the grease drain hole in the bottom of the grill to catch grease during use.
8