Brinkmann Gas Kettle Grill owner manual Filling the LP GAS Cylinder, Hose and Regulator

Page 6

WARNING

FILLING THE LP GAS CYLINDER:

Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder.

New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank.

DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can create a dangerous condition. Over-filled tanks can build-up pressure and cause the relief valve to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark source or flame an explosion causing severe burns, bodily harm, or death could occur.

Always use a protective cylinder cap when grill is not connected to cylinder.

If you exchange a cylinder with a qualified exchange program, be sure the cylinder has a Type 1 valve and an over-filling prevention device (OPD).

INSTALLING THE LP GAS CYLINDER ONTO THE GRILL:

1. Check that the cylinder valve is closed by turning the knob clockwise.

2.Place the cylinder onto the bottom shelf/tank support.

3.Orient the cylinder such that the valve opening does not kink or damage the supply hose.

HOSE AND REGULATOR:

Your grill is equipped with a Type 1 connection device with the following features:

HIGH

IGNITER

LOW

•Refer to owner's manual for match lighting

procedure.

For asisstance, call 1-800-527-0717.

Turn off LP gas cylinder after each use.

 

 

 

 

 

 

 

 

1.The system will not allow gas flow from the cylinder until a positive connection to the valve has been made. NOTE: The cylinder valve must be turned off before any connection is made or removed.

2.A thermal device that will shut off the gas flow if the device is subject to temperatures above 240°F and 300°F (115°C and 150°C). If this should happen, remove the entire regulator assembly and throw it away. A replacement regulator assembly can be purchased by contacting Brinkmann at 1-800-527-0717.

The cause of the excessive heat should be determined and corrected before using your grill again.

3.A flow limiting device, when activated, restricts the flow of gas to 10 cubic feet per hour.

5

Image 6
Contents Save this Manual for Future Reference Important Safety For Your SafetyPage Installation Information Cylinder SpecificationsPage Installing the LP GAS Cylinder Onto the Grill Filling the LP GAS CylinderHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder Leak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the BurnerMatch Lighting the Burner Breaking in Your Grill Turning OFF the GrillOperating the Grill Preheating the GrillControlling FLARE-UPS To Minimize FLARE-UPSBefore Storing Your Grill Cleaning and MaintenanceTransporting and Storage HardwareBurner and Venturi Cooking GrillsHeat Shield Trouble Shooting Problem Possible Causes Burner will not lightCleanliness Grilling to Proper TemperatureHelpful Hints Assembly Instructions Parts BAG Contents Step Align bottom shelf/tank support with holes in the legs Place dome lid on grill body and align hinges Place heat shield into lower grill body just above burner Grease cup Ashguard/grease cup holder Brinkmann Gas Kettle Grill Assembled Accessories 251-800-468-5252 Page ONE-YEAR Limited Warranty