Brinkmann 4 Burner Gas Grill Grill owner manual Lighting Instructions, Lighting the Main Burners

Page 11

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3.Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lids before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

3. Select the burner to be lit. Push and turn the control knob of that burner to the "HIGH" position.

4. Press the electronic igniter and hold for 3 – 5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.Repeat steps 3 – 5 for lighting each burner. Always use electronic igniter for lighting each burner. If burner does not ignite using the push-button igniter, wait 5 minutes, see "Match Lighting the Main Burners" section.

7.To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the cylinder.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

MATCH LIGHTING THE MAIN BURNERS:

1. Open lid before lighting.

Lighting Hole

2.Turn the burner control knobs to "OFF".

3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to

approximately 1/2" (1 to 2 cm) from the burner.

4. Turn on the FAR LEFT burner control knob to the "HIGH" position. The burner should light within 5 seconds.

Matchlighter

5. If the burner does not light, turn the control knob to "OFF" and wait

5 minutes for gas to dissipate and repeat lighting procedure.

6.To light other burners, push and turn control knobs to HIGH in sequence from left to right. Follow Step 5.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

10

Image 11
Contents Avis À L’INSTALLATEUR Important Safety Table of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Hose and Regulator Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Filling the LP GAS CylinderConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Lighting the Side BurnerMatch Lighting the Side Burner Controlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillSide Burner Rotisserie CookingHelpful Hints CleanlinessGrilling to Proper Temperature Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceBefore Storing Your Grill Cooking GrillsHeat Distribution Plates Transporting and StorageTrouble Shooting Frequently Asked Questions Frequently Asked Questions Parts BAG Contents Parts List Assembly InstructionsFor Grill Warranty Replacement PARTS, Please Visit US AT Step Locking Caster Hex Nut Wrench Step Place grease cup in middle of hole in heat shield plate Step Left Side Table Front Panel Right Side Table Side Burner Without leak testing all Gas connections Place the side burner grate onto the side burner table Step Charmglow 8403 Assembled Importantes Relatives LA Sécurité Mises EN GardeTable DES Matières Mises EN Garde Mises EN Garde GénéralesRenseignements SUR L’INSTALLATION Spécifications DE LA Bouteille Procédure DE Réenclenchement DU Régulateur Installation DE LA Bouteille DE GPL SUR LE GrilRemplissage DE LA Bouteille DE GPL Tuyau ET RégulateurRaccordement DE L’ENSEMBLE Tuyau / Détendeur Quand Effectuer UNE Épreuve D’ÉTANCHÉITÉ Épreuves D’ÉTANCHÉITÉListe DE Contrôle Avant L’ALLUMAGE Allumage DES Brûleurs Principaux À L’AIDE D’UNE Allumette Consignes D’ALLUMAGEAllumage DES Brûleurs Principaux Fermeture DU Gril Allumage DU Brûleur LatéralAllumage DU Brûleur Latéral À L’AIDE D’UNE Allumette Contrôle DES Embrasements Utilisation DU GrilMise EN Marche DE Votre Gril Préchauffage DU GrilBrûleur Latéral Cuisson AU TournebrocheConseils Utiles PropretéGrillage À LA Bonne Température Assemblage ET Entretien DES Brûleurs Nettoyage ET EntretienAvant Dentreposer Votre Gril Grilles DE CuissonPlaques DE Diffusion Thermique Transport ET EntreposageVérifier le niveau de de propane liquéfié dans la bouteille DépannageQuestions Posées Fréquemment Questions Posées Fréquemment Contenu DU SAC DE Pièces Contenu DU SAC DE PiècesListe DES Pièces Consignes D’ASSEMBLAGEPage Étape Remarque Retourner le chariot avec Roue Enjoliveur Boulon Essieu Patte Rondelle Plaque Pare-Chaleur Du Réservoir Contenant à Graisse Corps du Gril Étape Étape Bouton de Capuchon Charmglow 8403 Assemblé Warranty