Brinkmann 1575 owner manual Lighting Instructions, Match Lighting the Main Burners

Page 11

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3.Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

3. Select the burner to be lit. Push and turn the control knob of that burner to the "HIGH" position.

4.Press electronic igniter and hold for 3-5 seconds to light burner.

5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If burner does not ignite using the push-button igniter, wait 5 minutes, see “Match Lighting the Main Burners” section.

7.To turn off, turn each control knob clockwise until it locks in "OFF" position. This does not turn off the gas flow from the cylinder.

MATCH LIGHTING THE MAIN BURNERS:

1. Open lid before lighting.

 

Lighting Hole

 

 

2. Turn the burner control knobs to "OFF".

3.

Place a paper match in the end of the matchlighter. Strike the match

 

 

and place through lighting hole in the left hand side of the grill to

 

 

approximately 1/2" (1 to 2 cm) from the burner.

 

4.

Turn on the FAR LEFT burner control knob to the "HIGH" position.

 

 

The burner should light within 5 seconds.

 

5.

If the burner does not light, turn the control knob to "OFF" and wait

Matchlighter

 

5 minutes for gas to dissipate and repeat lighting procedure.

 

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the "HIGH" position.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

10

Image 11
Contents 1575 Important Safety Table of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Hose and Regulator Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Filling the LP GAS CylinderConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Lighting the Sear Burner Lighting the Rotisserie BurnerMatch Lighting the Rotisserie Burner Turning OFF the Grill Match Lighting the Sear BurnerControlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillSear Burner Rotisserie CookingHelpful Hints CleanlinessGrilling to Proper Temperature Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceTransporting and Storage Cooking GrillsHeat Distribution Plates Before Storing Your Grill Trouble ShootingFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Parts List Assembly InstructionsPage Step Locking Caster Hex Nut Wrench Lower Left/Upper Right Door Hinges Upper Left/Lower Right Spring Pin Door Pivot Hole Step Step Side Table Holes Thermocouple Sear Burner Nozzle Bracket Place the sear burner grate Step ProSeries 1575 Assembled Peligro Importantes Advertencias DE SeguridadÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Manguera Y Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoConexión DE LA Manguera Y Regulador Verificación DE Ausencia DE Fugas Pruebas DE Detección DE FugasCuándo Realizar UNA Prueba DE Detección DE Fugas ¡PRECAUCIÓN Lista DE Verificación Preliminar AL EncendidoEncendido DE LAS Hornillas Principales CON UN Cerillo Instrucciones DE EncendidoEncendido DE LAS Hornillas Principales Encendido DE LA Hornilla DE Rotisserie CON UN Cerillo Encendido DE LA Hornilla RotisserieApagado DE LA Parrilla Encendido DE LA Hornilla Para Dorar CON UN CerilloControl DE LAS Llamaradas Operación DE LA ParrillaPreparación DE LA Parrilla Para Usarla POR Primera VEZ Precalentamiento DE LA ParrillaLA Hornilla Para Dorar Cocción Estilo RotisserieRecomendaciones Útiles LimpiezaCocinar a LA Parrilla a LA Temperatura Apropiada INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Limpieza Y MantenimientoTransporte Y Almacenaje Continuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS HornillasRejillas Para Cocinar Placas DE Distribución DEL CalorAntes DE Guardar LA Parrilla Identificación Y Corrección DE ProblemasPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes Lista DE Partes Instrucciones DE ArmadoPage Paso Rueda Trabable Llave para Tuercas Hexagonales Paso Paso Paso Paso Advertencia Nunca use la Hornilla para Paso ProSeries 1575 Armada Warranty