Brinkmann 1575 owner manual Side Table Holes Thermocouple Sear Burner Nozzle Bracket

Side Table Holes

Figure 1 Figure 2

Thermocouple

Sear Burner Nozzle

Bracket

Step 17

Press the two raised points on the back of the bezel into the corresponding holes on the sear burner front panel. Then, firmly seat the valve nozzle into the burner venturi. Hold in place while you perform Step 18.

Step 18

Insert the two screws that are already attached on the sear burner valve through the corresponding key holes on the sear burner front panel and bezel, from the back of the sear burner front panel. Depending on the sear burner valve, you will be using either the outside key holes (Figure 1), or the inside key holes (Figure 2). Pull the valve downward or upward to lock into place. Then tighten the two screws.

Step 19

Insert thermocouple through the keyhole of the sear burner tray as shown and slide left .Tighten using wrench provided.

Step 20

Loosen the two pre-attached bolts from the sear burner tray. Insert bolts through the key holes of sear burner nozzle bracket and slide down. Tighten securely.

WARNING: Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

30