Brinkmann 1575 owner manual Match Lighting the Sear Burner, Turning OFF the Grill

To turn off the cylinder valve,

turn knob clockwise until it stops.

MATCH LIGHTING THE SEAR BURNER:

1.Open the lid to the sear burner before lighting.

2.Make sure control knob is in the "OFF" position.

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the sear burner.

4.Push and turn the sear burner control knob to the "HIGH" position. Continue to push in control knob while holding a match to burner. The burner should light within 5 seconds.

5.Once burner is lit, continue to push and hold control knob for 30 seconds.

6.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the sear burner until the problem is found and corrected. See "Trouble Shooting" section of this manual.

Note:	Observe flame height on main burners
	when lit: Flame should be a Blue/Yellow color
	between 1"–2" when burner is on "HIGH".

TURNING OFF THE GRILL:

1.Turn off the cylinder valve.

2.Turn all burner control knobs to the "OFF" position.

Note: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION:

• The cylinder valve should always be in the off, or closed,

position when the grill is not in use.

12