Teledyne 3190Z operating instructions Trace Oxygen Analyzer Operation

Trace Oxygen Analyzer Operation

Operation

4.1 Introduction

Once the analyzer has been mounted, the gas lines connected, and the electrical connections made, the analyzer can be configured for your application. This involves setting the system parameters as follows:

•Defining the user-selectable analysis ranges

•Setting alarm set-points.

•Calibrating the instrument

All of these functions are performed via the front panel controls, shown in Figure 4-1.

Analyzing a gas sample for the percent oxygen level through the cell block is the default mode of operation. The analyzer is monitoring the oxygen level as long as no front panel buttons have been pressed.

Figure 4-1: Front Panel Controls and Indicators

Teledyne Analytical Instruments 17