Invacare Pro Series manual Adjusting the T-ARMS, Width Figure, Height Figure, Depth Figure

ARMS			PROCEDURE 4
			T-arm Release
			Lever - Unlocked
			Position
	T-arm
		Set	Inside T-arm
		Screws	Post
Wheelchair		Outside T-
		arm Post
Frame	Locking Lever
	(Towards the		T-arm Release Lever -
T-arm	front of the		Locked Position
	wheelchair.)	FIGURE 4 - ADJUSTING THE T-ARMS -
Socket
	Slot		HEIGHT
FIGURE 3	- INSTALLING/REMOVING

THE T-ARMS	Width (FIGURE 5)
	1.	Remove the two (2) phillips screws that secure
ADJUSTING THE T-ARMS		the arm pad to the arm tube.
	2.	Turn the arm pad around and reposition the arm
Height (FIGURE 4)
		pad on the arm tube.
1. Unlock the T-arm by flipping the T-arm release le-	3.	Re-secure the arm pad to the arm tube with the
ver towards the inside of the wheelchair.		two (2) phillips screws. Tighten securely.
NOTE: If necessary, pull out on the T-arm release le-	4.	Repeat for the opposite side, if necessary.
ver and rotate 180o so it can be flipped towards the
outside of the wheelchair.

2. Slide the T-arm to one (1) of:

A.	Low Height T-arms- Nine (9) positions.	Arm Pad
B.	High Height T-arms- Seven (7) positions.		Arm Tube
NOTE: If the inside T-arm post does not slide up and		Phillips	Phillips Screw
down in the outside T-arm post as desired, perform		Screw
one (1) of the following:		FIGURE 5 - ADJUSTING THE T-ARMS -
A.	Tighten - Tightening the set screws on the
		WIDTH
	outside T-arm post will make it harder to
	move the inside T-arm post up and down.
B. Loosen - Loosening the set screws on the		Depth (FIGURE 6)
	outside T-arm post will make it easier to move
	the inside T-arm post up and down.	1. Remove the two (2) phillips screws that secure
3. Lock the T-arm by flipping the T-arm release lever		the arm pad to the arm tube.
towards the front of the wheelchair.		2. Remove the two (2) socket screws that secure

the arm tube to the T-arm post.

A R M S

2 9