Panasonic WV-CP310, WV-CP314 Flaw compensation PIX OFF, Communication setting Communication

Page 24

J Flaw compensation [PIX OFF]

Flaws of pixel in the displayed camera image are corrected. Up to 16 points can be corrected. Follow the procedure below.

Step 1

Move the cursor to "PIX OFF" and press the [SET] button.

The "PIX OFF" screen appears.

Step 2

Select a number (1 to 16) with which a pixel compensation point is registered and press the [SET] button.

The pixel compensation positioning screen appears.

Step 3

Use the [up], [down], [right], and [left] buttons to move the crosshair cursor to the center of the flaw to be corrected and press the [SET] button.

The flaw is corrected and the pixel compensation point is registered. The "PIX OFF" screen appears again. An asterisk "*" is attached at the right side of the number when registration is completed. The coordinate is expressed in figures.

Note:

To clear the registered pixel compensation point, move the cursor to “1” of the right of “DEL”, use the [right] and [left] buttons to select the number with which the target pixel compensation point is registered and press the [SET] button. The registered pixel compen- sation point is cleared, and an asterisk "*" at the right side of the number disappears.

K Communication setting [COMMUNICATION]

The required communication configuration is performed to use this unit integrated into the sys- tem with a receiver.

COAX (RCV): Select COAX (RCV) when using our decoder (e.g. WV-RC150).

COAX (default): Select this setting when not using any receiver.

24

Image 24
Contents Model No WV-CP310, WV-CP314 WV-CP300, WV-CP304 Preface Trademarks and registered trademarksContents About the setup menus List of setup menuBasic operation StepCamera Setup SCENE1 ALC Screen transition diagram CP310 Camera ID screenScreen transition diagram CP300 Camera title setting Camera ID Character entryCamera operation setting Camera Setup Register a scene file SCENE1/SCENE2Light quantity control method selection ALC/ELC Back light compensation functionElectronic shutter setting Shutter Gain control setting AGCElectronic sensitivity enhancement setting Sens UP White balance setting White BALManual fine adjustment of white balance Area setting screenDigital noise reduction function setting DNR Black-and-white mode settingD&N IR CP310 D&N ELE CP300CP310 VMD setting VMD Set motion detectionMotion DET screen Display Mode screen Setting of scene change detection Camera system setting System Setup Privacy zone setting Privacy Zone@ Synchronization method selection Sync Image stabilizer setting Stabilizer Electronic zoom setting EL-ZOOMUpside-down setting UPSIDE-DOWN Lens distortion correction LDCSpecial menu setting Special Setup Chroma level adjustment Chroma GainAperture level adjustment AP Gain Pedestal level adjustment PedestalCommunication setting Communication Flaw compensation PIX OFFDefault resetting Camera Reset Serial number viewing SER.NOCamera language selection Language Setup Language Setup screenSystem controller operation Setting contents Shortcut operationPanasonic Canada Inc