Resetting to Factory Defaults
Two procedures are available to return the video network station to its factory default settings: one using the RESET switch on the unit, and the other by remotely accessing the Administration Overview page from the network.
Note
The following procedure returns all settings, including the IP address of the device, to the factory default settings.
Resetting to Factory Defaults by the RESET Switch
1 Disconnect the power cable from the video network station.
2 Insert a long, thin implement to hold the RESET switch down.
z Hint
The RESET switch is located inside the small hole between the VIDEO 3 and VIDEO 4 terminals.
3 Reconnect the power cable while holding the RESET switch down.
4 When the STATUS indicator lights yellow, release the RESET switch.
After about five seconds, the video network station reboots.
The video network station settings are returned to their factory default values.
Resetting to Factory Defaults from the Administration Overview Page
1 Display a monitor screen in the Web browser, and click the Admin button.
The “Administration overview” page appears.
2 Click the [Network Station] icon.
The screen display changes to [General Settings].
3 Click the [Factory Default] button. A confirmation message appears.
4 Click [OK].
The video network station settings are returned to their factory default values.
37