Sony snt-v manual Installation Serial Port Settings, Setting Options Description

Installation

Serial Port Settings

The (COM1 and COM2) icons represent the serial ports of the video network station. Use these icons when an EVI-D30/D31/G20/G21 or HSR-1/1P/ 2/2P is connected to the “COM1” or “COM2” ports to set up serial port function and communications parameters.

Note

If a serial port has the Click “Save” icon enabled, the video network station reboots and alarm memory contents are erased, so check the alarm memory contents, if necessary, before setting.

1 Click the “COM1” (or “COM2”) icon.

The screen displays the “Serial Port 1 Settings” (or “Serial Port 2 Settings”).

2 Make the required settings. Available settings are as follows.

Setting	Options	Description
Purpose	Pan Tilt	Select this if an EVI-D30/
		D31/G20/G21 is connected to
		the port.
		When selected, the “Pan Tilt”
		icon shown below is added
		next to the “COM1” or
		“COM2” icon.
	HSR (only	Select this if an HSR-1/1P/2/
	displayed for	2P is connected to the port.
	COM1)	When selected, the “HSR”
		icon shown below is added
		next to the “COM1” icon.

Setting	Options	Description
Purpose	Modem	Select this if a modem is
	(only	connected to the port.
	displayed for	When selected, the “Modem”
	COM2)	and “ISP” icons shown below
		are displayed.
	None	Select this if no device is
		connected to a port.
Serial	Select the appropriate interface type:
Mode	[RS232] for the EVI-D30/D31/G20/G21 and
(only	HSR-1/1P/2/2P.
displayed
for
COM1)
Baud	Select the transfer speed: Select [9600] for
Rate	the EVI-D30/D31/G20/G21, or [1200] to
(bps)	[38400] as the HSR setting to match that of
	the HSR-1/1P/2/2P.
Data Bits	Select [8] data bits for the EVI-D30/D31/
(length)	G20/G21 and HSR-1/1P/2/2P.
Stop Bits	Select [1] stop bit for the EVI-D30/D31/G20/
	G21 and HSR-1/1P/2/2P.
Parity Bit	Select [None] for the EVI-D30/D31/G20/
	G21 and HSR-1/1P/2/2P.

3 Click the “Save” icon when finished with the settings.

The new settings are saved, the video network station reboots, and the display changes as follows depending on the selected usage.

•When [Pan Tilt] is selected, the “Pan Tilt Settings” page appears. Refer to “Pan/Tilt Driver and Video Camera ID Setup” below.

•When [HSR] is selected, the “Sony HSR Settings” page appears. Refer to “HSR-1/1P/2/2P Setup” on page 20.

•When “Modem” is selected, the “Modem Settings” page appears. Refer to “Modem Setup” on page 22. Also, to set up dial-up connection via modem, refer to “ISP (Internet Service Provider) Setup” on page 22.

18