Omega DP119-RTD manual Installation Information

Page 18

			PANEL THICKNESS
			0.25 [6.4]			MAX
			0.03 [0.8]			MIN
1/8 DIN PANEL CUTOUT
	R 0.06

			1.772		+0.024/-.000
[1.5]			1.772		+0.024/-.000
	4PLCS		[45.0		+0.61/-0.00]
3.622 +0.032/-.000
3.622 +0.032/-.000
		[92.00	+0.81/-0.00]

	SCREWS
	METER
	BEZEL
LENS	BACKPLATE
	BACKPLATE
	PANEL WITH
	1/8 DIN CUTOUT

Figure 3-4. Installation Information

11

Image 18

Contents DP119-RTD For immediate technical or application assistance Table of Contents Section Preface Models Available RTD Models Available ResolutionModelpower Model TypeOther Models Available Page Introduction Unpacking QTY DescriptionSafety Considerations Unpacking & InspectionAbout the Meter Front of the MeterPIN # EXC+EXC Getting Started 3.1 Main Board Power Jumpers AC Voltage Install Remove 1shows the location of solder jumpers W1 through W3Changing the Meter Parameters 2shows the location of the jumper plugs S1 through S5Following tables summarizes what parameters you can change Example of How to Set Meter Option MF1 Jumpers S4 and S5 Sensor Break ProtectionInstallation and Panel Mounting Installation Information Wire RTD Sensor Input ConnectionsWire colors are for Omega RTD wiring only Analog Output Connections Analog Output Connections P22shows the location of the P2 connector on the meter Display Hold ConnectionsMain Power Connections Ð2 shows the location of P1 on the meterDC Wiring 2shows the location of P1 on the meterDisassembly/Assembly Pull TAB Here PC Board Push Here Operation and Calibration Equipment RequiredCalibration Procedure Wire ConfigurationZero Specifications Display Dimensions Glossary Page USAWARRANTY/DISCLAIMER Temperature