Omega DP119-RTD manual Introduction Unpacking, QTY Description

Page 8

SECTION 1 INTRODUCTION

1.1 UNPACKING

Remove the Packing List and verify that all equipment has been received. If there are any questions about the shipment, use the phone number for the Customer Service Department nearest you.

Upon receipt of shipment, inspect the container and equipment for any signs of damage. Take particular note of any evidence of rough handling in transit. Immediately report any damage to the shipping agent.

The carrier will not honor any claims unless all shipping Note material is saved for their examination. After examining and removing contents, save packing material and

carton in the event reshipment is necessary.

Verify that you received the following items in the shipping box:

QTY DESCRIPTION

1Panel Thermometer with 3 small connectors plugged into the rear of the meter.

1OperatorÕs Manual

1

Image 8
Contents DP119-RTD For immediate technical or application assistance Table of Contents Section Preface Resolution ModelpowerModels Available RTD Models Available Model TypeOther Models Available Page Introduction Unpacking QTY DescriptionSafety Considerations Unpacking & InspectionAbout the Meter Front of the Meter+EXC PIN #EXC Getting Started 3.1 Main Board Power Jumpers AC Voltage Install Remove 1shows the location of solder jumpers W1 through W3Changing the Meter Parameters 2shows the location of the jumper plugs S1 through S5Following tables summarizes what parameters you can change Example of How to Set Meter Option MF1 Jumpers S4 and S5 Sensor Break ProtectionInstallation and Panel Mounting Installation Information Wire RTD Sensor Input ConnectionsWire colors are for Omega RTD wiring only Analog Output Connections Analog Output Connections P22shows the location of the P2 connector on the meter Display Hold ConnectionsMain Power Connections Ð2 shows the location of P1 on the meterDC Wiring 2shows the location of P1 on the meterDisassembly/Assembly Pull TAB Here PC Board Push Here Operation and Calibration Equipment RequiredCalibration Procedure Wire ConfigurationZero Specifications Display Dimensions Glossary Page USAWARRANTY/DISCLAIMER Temperature