Invacare 636959 instruction sheet Operating Instructions, Grounding Instructions, Set-Up

Grounding Instructions

WARNING

DO NOT, under any circumstances, cut or remove the round grounding prong from any plug used with or for Invacare products. Some devices are equipped with three-prong (grounding) plugs for protection against possible shock hazards. Where a two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have the two-prong receptacle replaced with a properly grounded three-prong wall receptacle in accordance with the National Elec- trical Code. If you must use an extension cord, use ONLY a three-wire exten- sion cord having the same or higher electrical rating as the device being connected.

Operating Instructions

Set-Up

NOTE: For this procedure, refer to FIGURE 1 on page 4.

1.Place unit on a table top or flat work surface.

2.Check that the power switch is Off (O). Refer to Detail “A”.

3.If the unit is cold, let the unit reach room temperature before plugging it in.

4.Connect one end of the connection tubing to the elbow connector on top of the collection bottle, and connect the other end of the connection tubing to the hydrophobic filter.

5.Connect the second length of connection tubing between the hydrophobic filter and the vacuum port barb.

6.Connect the suction tubing to the labeled patient connector (outlet) on the collection bottle.

Part No 636959 3 Aspirator Suction Unit