Bodyline Products International AX-2330 Mount. fig Remove inner cutter assembly, Trimmer Cleaning

3.	Remove loose hairs from inside	3 4
head assembly with brush. (fig. 3)
4.	Remove loose hairs on cutter
mount. (fig. 4)

5. Remove inner cutter assembly

by turning the center knob counter clockwise and lift out. (fig. 5) Clean hairs off with brush supplied. To maximize shaving comfort and closeness, periodically remove the head assembly to determine if your shaver needs cleaning, particularly if you have a heavy beard and use

the shaver daily. If you routinely check the amount of shaven hairs
under the head and clean the entire head assembly	5
when necessary, your shaver will always run at peak
performance. After cleaning, replace the inner cutter
assembly back into place.

Important! Make sure that the center knob is locked into place by pushing down and turning clockwise.

After cleaning, always replace the plastic head guard to protect the floating heads.

Trimmer Cleaning

Turn shaver off and open trimmer by pushing the trimmer button upward.

Using the brush, clean outside and inside of trimmer after each use.

When finished, close trimmer by sliding trimmer button down.

AXIS ORBIT 4000 AND ORBIT 2000 16 ENGLISH AXIS ORBIT 4000 AND ORBIT 2000 17 ENGLISH