UV CROSSLINKERS | UVP |
Push START on the touchpad. After a slight delay to energize the UV tubes, The LED will begin to countdown. the unit will stop automatically at the end of the exposure cycle and will beep five times. Exposure is now complete.
D.User set UV time exposure
Setting your own UV time exposure can be achieved as follows:
Push the TIME on the tactile touchpad and then set your requirements by pushing the numbers. Your time exposure settings will be displayed on the LED in flashing mode. REMEMBER THAT YOUR TIME EXPOSURE SETTINGS ARE SET IN MINUTES AND TENTHS OF A MINUTE. If your settings are correct, push ENTER on the tactile touchpad.
Push START.
After a slight delay to energize the UV tubes, the LED will begin to countdown. The unit will stop automatically at the end of the exposure cycle and will beep five times. Exposure is now complete.
8.At the end of the exposure cycle, simply open the door and remove your sample.
9.Operational Notes:
A.To abort an exposure, press STOP on the tactile touchpad. The LED will display the remaining exposure.
B.To restart an aborted exposure, press START on the touchpad. The exposure will continue from the point at which the exposure was aborted.
C.To reset an aborted exposure, press the RESET. The LED and touchpad will return to the used last setting.
D.The unit will not operate with the door open. Opening the door during a cycle aborts the cycle. Reclosing the door will reset the cycle to the last entered cycle used. To restart, press the START key.
-5 -