operation
LOWERING THE MAST
1.Loosen the
SECOND
MAST
2.Connect the AC power cable to the 120 VAC receptacle on the generator used. See Figure 23.
120VAC
RECEPTACLE
| 20A | TYPICAL |
|
| |
POWER |
| GENERATOR |
| FRONT PANEL | |
CABLE |
| |
|
| |
| 120V |
|
Figure 23. Connecting to Power Source
3.Start the generator as indicated in the generator manual.
Figure 20. Lowering Second Mast
2.Push the lock/release tab on the third mast to release it and lower third mast. See Figure 21.
LOCK/
THIRD RELEASE
MAST TAB
4.Turn on the Power ON/OFF switch (Figure 22). The balloon will start to inflate and the lamp will turn on.
DIMMING THE LAMP
1.Slightly unzip the bottom of the balloon to gain access to the dimmer switch (Figure 24).
BALLOON
Figure 21. Lowering Third Mast
APPLYING POWER
1.Before applying power, make sure that the Power ON/OFF switch (Figure 22) is in the OFF position.
POWER
ON/OFF
SWITCH
0 | 1 |
|
ZIPPER
Figure 24. Unzipping Balloon
2.Press the dimmer switch lightly (Figure 25). The LED will blink.The lamp should dim to about 75% brightness.
DIMMER
SWITCH
0 | 1 |
|
Figure 22. ON/OFF Switch Figure 25. Dimmer Switch
page 22 — GBC lighting system • operation and parts manual — rev. #0 (06/24/13)