an & dr | y |
cle | |
| clean |
fast clean | |
an & dry |
|
cle | clean |
n |
|
f ast clea |
|
high |
|
low |
|
an & dr | y |
|
cle | clean | |
|
| |
fast clean |
| |
| an & dry |
|
| cle | clean |
| n |
|
| f ast clea |
|
high
low 
empty
| y | y | |
r |
| h | |
| g | ||
e |
| ||
t |
|
| i |
t |
|
| |
a |
| e | |
b | e | n | |
|
|
|
|
«clean» | shaver is clean |
«
» short economical cleaning required
«
» normal level of cleaning required
«
» high intensive cleaning required
If the station selects one of the required cleaning programs, it will not start unless you press
the «clean & dry» button 4. For best shaving results, we recommend cleaning after each shave.
Whilst cleaning is in progress, the respective cleaning program indicator will blink. Each cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head and a heat drying process dries the shaver. Depending on the program selected the total cleaning time will range from 32 to 43 minutes.
The cleaning programs should not be inter- rupted. Please note that whilst the shaver is drying, the shaving head may be hot and wet. When the program is finished, the blue «clean» indicator will light up. Your shaver is now clean and ready for use.
Fast cleaning
Push the «fast clean» button D to activate the fast clean program without drying. This program takes about 25 seconds only and is recommended when you do not have time to wait for one of the automatic cleaning programs. If you remove the shaver just after the program has finished, wipe off the shaver head with a tissue to avoid dripping.
Stand-by mode
10 minutes after completing the charging or cleaning session, the Clean&Renew station switches to the
Shaver display
The shaver display z shows the charge status of the battery on the left, and the hygiene status on the right. (6 dark segments are shown on each side when the battery is fully charged and the shaver is hygienically clean).
14