EN
RECEPTION OF SENSOR SIGNAL
OPERATING THETEMPERATURETATION
1.Remove the battery door and insert 2 new AAA size batteries as per the polarity information marked on the battery compartment.
2.Press “RESET” key.
3.Slide “°C/°F” switch to select between °C and °F.
4.Slide the battery door back on.
5.Press “CHANNEL” key to select the desired channel.
Main unit is searching for the sensor(s) (the icon will be flashing)
| The sensor(s) cannot be found |
|
|
| Sensor 1 has been found |
| (the icon will be displayed, |
| but won't flash) |
and | The sensor(s) cannot be found after |
(Outdoor | |
temperature | operating the main unit for 60 minutes |
Area) |
|
Note When the sensor signal is received, the icon “ ” will be displayed on the LCD.
OPERATING THE SENSOR
1.Remove the battery door and slide the “CHANNEL” switch to CH 1.(When using additional sensors, make sure each sensor is assigned a different CHANNEL number.)
2.Insert 2 new AAA size batteries, matching
3.Press “RESET” key.
4.Slide the battery door back on.
Note
Tip the transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.
Standard Alkaline batteries contain significant amounts of water. Because of this they will freeze in low temperatures of approximately
Wireless ranges can be impacted by a variety of factors such as extremely cold temperatures. Extreme cold may temporarily reduce the effective range between the sensor and the base station. If the unit’s
4