Fluke Food Safety Thermometer user manual Probe Replacement, Battery Insertion and Replacement

Page 20

FoodPro Plus

Users Manual

Probe Replacement

The modular probe of the food safety thermometer is replaceable. To replace probe, extend the probe partially to access the rubber caps. Carefully pry up the rubber caps using a pin, and remove the screws using a #2 cross-tip screwdriver as shown. Grasp the probe and carefully separate the old probe from the probe base. Install the new probe in the reverse order, firmly tightening the screws and replacing the rubber plugs. The calibration accuracy of the unit is not affected by probe replacement (Figure 14).

ebq17.eps

Figure 14. Probe Replacement

Battery Insertion and Replacement

To install a new 9V battery, remove the rubberized battery compartment “plug” at the base of the unit by grasping the sides of the cover and pulling straight out, exposing the battery. Gently shake or tap the base of the unit on your palm to gain access to the battery. The 9V battery of the unit is connected to the polarized snap connector (Figure 15).

ebq18.eps

Figure 15. Battery Insertion and Replacement

16

Page 19 Page 21
Image 20
Page 19 Page 21
Contents FoodPro Plus Limited Warranty and Limitation of Liability Table of Contents FoodPro Plus Noncontact Food Safety Thermometer Product StatementFoodPro Plus Specifications and Features Specifications and Features InfraredNoncontact Food Safety Thermometer Before You Start Noncontact Infrared ModeProper Application and Operation Mode Selection Probe ModeCountdown Timer Mode Extended Contact ProbeCountdown Timer Display Haccp CheckMeasuring Packaged Products in Cold Storage Cases Noncontact Temperature Measurement ApplicationsMeasuring Liquid Temperatures Measuring Food at the Receiving Dock Measuring Food in Holding and Serving AreasInfrared IRT and Probe channels RTD Cold Temperature Verification CheckField Verification of Accuracy Hot Temperature Verification Check Field Verification of AccuracyHot Temperature Verification Check Field of ViewOperating and Ambient Temperature Range Response TimeSetting/Changing ºC and ºF Temperature Scales HumidityEmissivity Selecting the C ScaleCleaning Instructions Setting/Changing ºC and ºF Temperature ScalesProbe Replacement Battery Insertion and ReplacementTroubleshooting Other Operational ConsiderationsCertifications
Top Page Image Contents