Graham Field US0208PL, US0458 user manual All models Install bed end locking hardware

All models: Install bed end locking hardware

1.After bed head end has been attached, install Bed End Locking Hardware to act as a latch for each corner.

Bed End Locking Hardware, part number

690-1000-100, includes four lanyards, each as- sembled from a clevis pin, hairpin clip, fender washer, and nylon cord, as shown at right. Bed end locking hardware, while not necessary for normal bed operation, will prevent the bed ends from accidentally rolling off when mov- ing or pushing the bed, or while installing or using bed-mount trapezes.

nylon cord

fender washer

clevis pin	hairpin
with hole	clip

Lanyard

WARNING: GF Health Products, Inc. recommends the use of Bed End Locking Hardware at all times.

bed end

frame bracket

bed end bracket (corner lock)

	lanyard —
	hairpin clip
a	removed	b	c

2.Refer to accompanying illustrations while installing Bed End Locking Hardware. Remove the hairpin clip from the end of the lanyard assembly, as shown in a, and set it aside.

3.Align the cord end with the frame bracket top hole closest to the bed end. Insert the cord end through the hole so that an equal amount of cord extends outside either side of the frame bracket hole, as shown in b.

4.The lanyard assembly will now hang loosely with the clevis pin and fender washer end on the outside, as shown in c.

US0208-INS-LAB-RevD11 • Patriot Homecare Bed 10