Install motor slide caps
7.Position the caps as shown at right so that the grooves in the slide cap are aligned with the grooves in the motor.
8.Apply straight downward pressure to each end of the cap while sliding into the closed position.
9.Repeat step 8 for the other cap.
10.Ensure that all four corners of each slide cap are engaged.
pressure
slide cap
motor
Install motor slide caps
WARNING: Ensure that the motor is assem- bled on bed as instructed above before use.
Motor assembly troubleshooting
Problems associated with improper motor installation are listed below, with appropriate fix.
Problem | Probable cause | Fix |
Head operates with knee control button and | Motor is installed backwards | Remove motor and reverse it (see previ- |
knee operates with head control button |
| ous page) |
Knee lifting linkages bind against grid | Motor is installed backwards, enabling | Remove motor and reverse it (see previ- |
deck, preventing knee deck from elevating. | knee to elevate too high and bind linkage | ous page) |
7 |