Graham Field US0208PL, US0458 user manual Motor Assembly, Remove motor slide caps, Install Motors

Page 6

MOTOR ASSEMBLY

WARNING: Assemble motor on bed as follows. While it is possible to install the motor backwards, avoid it! Incorrect installation could cause the bed to move in unexpected ways. Note that the motor ends are labeled and embossed with head and foot symbols (shown at right). Ensure that bed head and motor head, and bed foot and motor foot, are matched.

Head

Foot

Remove motor slide caps

slide cap

motor

Remove motor slide caps

1.Remove the slide caps from both ends of the motor as shown above. Plungers should be recessed in motor cavities; if not, plug the power cord into any grounded outlet and operate “down” func- tion on the pendant hand control, then unplug the power cord.

Info: Motor comes from factory with pendant hand control plugged into motor.

2. Install 9V backup battery (not provided) and slide into storage area.

Install Motors

cam

head

foot

tap here

Install motor

3.Hold the bed securely, positioned with motor cams up, as shown above.

4.Position the motor over both cams.

5.Tap either end of the motor housing (shown below) with enough force to snap the motor as- sembly into position on the cam.

6.Repeat step 5 for other end of motor.

US0208-INS-LAB-RevD11 • Patriot Homecare Bed

6

Image 6
Contents US0208-INS-LAB-RevD11 Contents Safety GRAVITY-DOWN Feature for Head and Knee Elevation Thermal Motor ProtectionAssembly Instructions Head and Foot AssemblyMotor Assembly Install MotorsRemove motor slide caps Install motor slide caps Motor assembly troubleshootingProblem Probable cause Fix FULL-ELECTRIC BED only US0458 / US0458PL Caster Position Standard conventional bed heightLow bed height BED END Assembly All bed models Assemble bed head endAll models Assemble bed foot end All models Install bed end locking hardware US0208-INS-LAB-RevD11 Patriot Homecare Bed Unplug the power cord HI/LO ROD Assembly / BED Length Semi-electric bed only US0208 / US0208PL Assemble hi/lo rodFull-electric bed only US0458 / US0458PL Assemble hi/lo rod All models Attach hi/lo rod to gearbox or motor shaft pins Foot ENDSemi-electric bed only US0208 / US0208PL BED OperationPendant Hand Control Operation Full-electric bed only US0458 / US0458PLCrank Operation SEMI-ELECTRIC BED only US0208 / US0208PL SPECIFICATIONS, ALL Models Lumex Patriot Liberty BED Rails Accessories BED RailsBED Rail Safety GF6500B-1 Assist BarGF6580B-1 Quarter Rail GF6590B-1 Half No-Gap Head RailGF6570B-1 Full Length Rail Lumex Universal BED Rails GF6570A-1 Full Length Side RailLX5088 No-Gap Bed Rail GF6580A-1 Low Universal Half Rail Info Suggested rail-to-headboard minimum is 9.25 inchesService PARTS, ALL Models BED ComponentsPart number Description Semi-electric Full-electric BED END Components BED Service Parts Part number DescriptionMaintenance and Safety Checks Warranty Index Northeast Parkway Atlanta, Georgia 30360 telephone