8 MAINTENANCE AND SAFETY CHECKS
Perform the following as needed or between patient placements, whichever happens sooner:
Electronics and | Check all controls to ensure that all functions work |
| Foot control |
Motors | properly. |
|
|
| Head control | ||
|
|
|
|
|
|
| Hi/Lo (if applicable) |
| Check all cables for damaged or frayed wires. |
| Power cord |
|
|
|
|
|
|
| Pendant hand control cord |
|
|
| |
| Check to ensure that all plugs are fully inserted or attached. | ||
| Check to ensure that all wires are routed and attached properly so not to interfere with any moving parts. | ||
|
|
| |
| Inspect motor casings for excessive wear and cracks |
| |
|
| ||
| Inspect motor slide caps for excessive wear and deformation | ||
Bed frames and | Visually check all welds |
| Head section |
sleeping surface |
|
|
|
|
| Foot section | |
|
|
|
|
|
|
| Main Frame |
| Check joints between sleeping surface sections for loose fasteners. | ||
|
| ||
| Inspect frames and sleeping surface for bending and excessive wear | ||
|
| ||
Cleaning | The metal parts of the bed are covered with a powder coating. Clean all coated parts with mild detergent | ||
| and warm water. Periodically raise head and foot sections of the bed and remove dust from frame. Also, | ||
| periodically remove mattress and clean mattress deck. |
| |
Lubrication and | Lubricate all caster roller and swivel bearings with light machine oil. | ||
mechanical | Check all bolts and tighten as needed. |
| |
WARNING: The bed’s electronic system contains no serviceable parts. Do not open the motors, cables, or pendant hand control. Only an authorized equipment provider or factory- trained personnel may perform service or adjustments on these components.
| 25 |