Assemble hi/lo motor shaft to foot end gear box
FOOT | hi/lo motor |
| |
END |
|
notches in hi/lo motor shaft coupler |
|
slide over gear box shaft pin |
|
gear box 
hi/lo motor shaft
Attach hi/lo motor shaft
to foot end gear box
You must first attach the coupler end of the motor shaft to the
1.Note the position of the hi/lo motor plug on the Okimat actuator next to the pendant hand control plug — plug the hi/lo motor into the actuator, routing the hi/lo motor cord under the fixed base frame
2.Plug the power cord into any grounded outlet.
3.Pull the motor shaft toward the foot end. Using the hi/lo function on your pendant hand con- trol, slowly turn the hi/lo motor shaft until the coupler matches up with the gear box shaft pin as shown above.
4.Slide the coupler until it rests completely on the pin. You may need to manipulate the foot end slightly from side to side and/or lift the hi/lo motor itself for proper alignment.
5.Unplug the power cord.
HEAD
FOOT
Route cord under
| 12 |