Genie TZ-50 manual Check the Engine Oil Level if equipped, Scheduled Maintenance

Page 17

Second Edition • First Printing	Operator's Manual

Check the Engine Oil Level (if equipped)

Maintaining the proper engine oil level is essential to good engine performance and service life. Operating the machine with an improper oil level can damage engine components.

Check the oil level with the engine off.

1 Check the oil level dipstick.

Result: The oil must touch the dipstick.

2 If oil is low, fill to the edge of the oil filler hole.

Honda GX160K1

Oil viscosity requirements

-4° to 100°F / -20° to 38°C	10W-30

Below 30°F / 0°C	5W-30

Above 50°F / 10°C	30W

Engine oil should have properties of API classification SJ.

MAINTENANCE

Scheduled Maintenance

Maintenance performed quarterly, annually, semi- annually and every two years must be completed by a person trained and qualified to perform maintenance on this machine according to the procedures found in the service manual for this machine.

Machines that have been out of service for more than three months must receive the quarterly inspection before they are put back into service.

Part No. 114164

Genie TZ-50

15

Image 17

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsMaximum allowable manual force CE and Australia 400 N Collision Hazards Fall HazardsExplosion and Fire Hazards Component Damage HazardsTowing Hazards Damaged Machine HazardsBodily Injury Hazard Decal Legend Optional Drive System Safety Tip-over HazardsExplosion Hazards Battery Safety Burn HazardsTip-over Hazard Lifting HazardGround Control Panel ControlsPlatform Control Panel StopDrive Control Panel Option StopFundamentals Pre-operation Inspection Pre-operation Inspection Maintenance Symbols Legend MaintenanceObserve and Obey Check the BatteriesCheck the Hydraulic Oil Level Check the Tires and WheelsCheck the Engine Oil Level if equipped Scheduled MaintenanceFunction Tests Setup for Function TestsTest the Parking Brake Test Boom Functions and Function EnableAt the Ground Controls Test Emergency StopTest the Tilt Sensor At the Platform ControlsTest Outrigger Interlock Test Drive and Brake System if equipped Workplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsEmergency Stop Operation from Ground Setup for OperationOperation from Platform Starting the Engine if equippedAll models except Australia Manual Operation of FunctionsAustralian models only Manual Operation of Jib Australian models onlyOptional Drive System Operation Platform Overload Indicator Light if equippedFall Protection To determine the slope grade Driving on a slopeStorage After Each UseMoving Machine Without a Tow Vehicle TowingTowing Information Charging the Batteries with the AC Charger Battery Charging Instructions Observe and ObeyCharging the Batteries with the Engine Transport and Lifting Instructions Securing the Chassis Securing to Truck or Trailer for TransitAxis Chassis Lifting Points Lifting InstructionsCenter of Gravity Table Inspection for Decals with Words DecalsPlatform End Ground Controls SideInspection for Decals with Symbols Ground Controls Side Power source SpecificationsRange of Motion Chart Genie Industries PO Box Redmond, WA Reporting Safety DefectsReporting Safety Defects Before Driving Before Towing