Genie TZ-50 manual Lifting Instructions, Center of Gravity Table, Axis Chassis Lifting Points

Page 33

Second Edition • First Printing	Operator's Manual

TRANSPORT AND LIFTING INSTRUCTIONS

Observe and Obey:

Only qualified riggers should rig and lift the machine.

Be sure the crane capacity, loading surfaces and straps or lines are sufficient to withstand the machine weight. See the serial plate for the machine weight.

Lifting Instructions

Fully lower and retract the boom.

Securely latch the boom hold-down latches.

Raise all four outriggers to the stowed position.

Remove all loose items on the machine.

Determine the center of gravity of your machine using the table and pictures on this page. Measure from one of the lifting points on the tongue end of the machine.

Attach the rigging only to the designated lifting points on the machine.

Adjust the rigging to prevent damage to the machine and to keep the machine level.

Center of Gravity Table

	X Axis	Y Axis

ANSI, CSA and Australia	13.5 in	16 in
	34 cm	41 cm

CE	12.4 in	16 in
	31 cm	41 cm

Tie-down

point Lifting point

Y axis
Chassis	Chassis
Lifting	Lifting
Points (2)	Points (2)
	X axis

Part No. 114164

Genie TZ-50

31

Image 33

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsMaximum allowable manual force CE and Australia 400 N Collision Hazards Fall HazardsExplosion and Fire Hazards Component Damage HazardsDamaged Machine Hazards Bodily Injury HazardTowing Hazards Decal Legend Optional Drive System Safety Tip-over HazardsExplosion Hazards Battery Safety Burn HazardsTip-over Hazard Lifting HazardGround Control Panel ControlsPlatform Control Panel StopDrive Control Panel Option StopFundamentals Pre-operation InspectionPre-operation Inspection Maintenance Symbols Legend MaintenanceObserve and Obey Check the BatteriesCheck the Hydraulic Oil Level Check the Tires and WheelsCheck the Engine Oil Level if equipped Scheduled MaintenanceFunction Tests Setup for Function TestsTest the Parking Brake Test Boom Functions and Function EnableAt the Ground Controls Test Emergency StopAt the Platform Controls Test Outrigger InterlockTest the Tilt Sensor Test Drive and Brake System if equipped Workplace Inspection Workplace InspectionOperating Instructions Emergency StopOnly use the machine as it was intended Operation from Ground Setup for OperationOperation from Platform Starting the Engine if equippedAll models except Australia Manual Operation of FunctionsAustralian models only Manual Operation of Jib Australian models onlyPlatform Overload Indicator Light if equipped Fall ProtectionOptional Drive System Operation To determine the slope grade Driving on a slopeStorage After Each UseMoving Machine Without a Tow Vehicle TowingTowing Information Battery Charging Instructions Observe and Obey Charging the Batteries with the Engine Charging the Batteries with the AC Charger Transport and Lifting Instructions Securing the Chassis Securing to Truck or Trailer for TransitLifting Instructions Center of Gravity TableAxis Chassis Lifting Points Inspection for Decals with Words DecalsPlatform End Ground Controls SideInspection for Decals with Symbols Ground Controls Side Power source SpecificationsRange of Motion Chart Reporting Safety Defects Reporting Safety DefectsGenie Industries PO Box Redmond, WA Before Driving Before Towing