Assembly
Lamp housing
The Leica 106Z lamp housing is equipped..
For information about the supply units for the 106Z lamp housing, see page 14..
Model 105Z lamp housings, if available, can also be used..
Observe the safety regulations on page 5
Notes and recommendations
•Do not switch on and off more than necessary, because this will shorten the burner life
•Hot
•If possible,
•Be very careful when fitting the burner.
Do not apply pressure, as it breaks easily
•Never touch the glass envelope of the burner with your fin-
gers.. Fingerprintslater burn in and reduce the light quality.. If necessary, carefully remove fingerprints and dust using a
cloth damped with alcohol and then wipe dry..
Fitting and changing the mercury-vapour burner
For the l06Z lamp housing, use the 100W
The
–Units which are unmarked or are marked L1 are for lower
currents and higher voltages ..
–Units marked L2 are for higher currents and lower voltages (see page 14)..
▶Slacken the two Phillips screws
▶Pull the disconnect plug slightly out
without turning it
▶Flip open the cover
▶ Slacken the Phillips screws
▶ Carefully extract the soc- ket, complete
with burner mount and connecting cable
▶Slacken the
▶Remove the transport peg and keep it for subsequent transport
▶Dispose of old
•When a new
▶Carefully insert the
▶For
▶Carefully position the flexible power cable on the upper metal mount of the
▶ Tighten the upper and lower screws with great care
▶ Introduce the burner mount, complete
with burner, into the rail of the lamp housing..
▶ Tighten the screws
12