GE 29438 manual Wall Mount Installation, Connect the phone cord to the modular Jack on the wall

WALL MOUNT INSTALLATION

1. Remove the mounting bracket from the	3	2
back by pressing down on the snap tabs
located at the top, and then lifting it off.		6
2. Plug the phone line cord into the
phone jack on the back of the unit,		5
wrap the extra line cord around the
cord wrap on the bottom of the base,
and then thread it through the bottom		4
of the mounting bracket.
3. Plug the power supply into the POWER
9V DC jack on the back of the unit, and
then thread it through the bottom of
the base.		7

4.Reverse the direction of the mounting bracket and replace it by putting the

tabs into the slots on the top of the unit

first, and then snapping the bottom tabs 8 into place.

5. Connect the phone cord to the modular	3	11
	1	9
jack on the wall.	2	10
	6	14
	4	12
	5	13
	7	15
		LOWER

6.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (mounting bracket not included.)

816

TWO LINE DATAPHONE

SET	MEMO
FLASH BUSY REDIAL PAUSE	REDIAL
	CONF

1 2 3 line2

4 5 6

7.Connect the DC power supply to an AC outlet.

8.Rotate the handset hook.

9.Plug the handset cord into the handset and into the unit, and then hang up the handset.

7	8		line1
			9
*	0	#	HOLD
		VOL
MUTE			SPEAKER

9

CAUTION: Use only the ATLINKS USA, Inc. 5-2366 power supply that came with this unit. Using other adapters can seriously damage the unit.

7