GE 28118 manual Area Code, Tone/Pulse, Registration

Area Code

From the Handset Setup Menu:

1.Press the vol/CID ( 6 or 5) button to scroll to the AREA CODE sub-menu.

2.Press the menu ok/mute button to enter the menu. SET AREA CODE - - - shows in the display. The default setting is - - -.

3.Use the touch-tone pad to enter your 3-digit area code.

4.Press the menu ok/mute button to confirm. You will hear a confirmation tone and the new area code shows in the display.

NOTE: To restore the default setting to - - -, press and release the del/conf/ intercom button when SET AREA CODE shows in the display.

Tone/Pulse

From the Handset Setup Menu:

1.Press the vol/CID ( 5 or 6) button to scroll to the TONE PULSE sub-menu.

2.Press the menu ok/mute button to enter the menu. TONE/PULSE 41TONE 2PULSE shows in the display. The default setting is “1 TONE”.

3.Use the touch-tone pad or vol/CID ( 5 or 6) to enter 1 TONE or 2 PULSE.

4.Press the menu ok/mute button to confirm. You will hear a confirmation tone and your selection shows in the display.

Registration

Your packaged handset(s) are pre-registered and ready to use. It is not recommended that a handset be registered again unless absolutely necessary.

From the Handset Setup Menu:

1.Press the vol/CID ( 6 or 5) button to scroll to the REGISTRATION sub-menu.

2.Press the menu ok/mute button to enter the menu. REGISTRATION 1YES 42NO shows in the display. The default setting is 2NO.

3.Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the vol/CID ( 6 or 5) button to scroll to 1YES or 2NO.

4.If you select YES, press the menu ok/mute button. HOLD BASE PAGE FOR 5 SECONDS, THEN PRESS HANDSET MENU OK shows in the display. (Your handset should be held near the base during registration process.)

21