Topcom 3350 manual Subscribing a Topcom Butler 300 Dect GAP Headset

Page 14

Topcom Butler 3350/Twin/Triple/Quattro

You only need to subscribe the handset if:

The handset subscription has been removed from the base unit (e.g. for reinitialisation)

You want to subscribe a different handset to this base unit.

The underlined procedure is only applicable to a Topcom Butler 32xx and 33xx handset and base unit!!

Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly

for one minute. During this minute, the base unit is in register mode and you must do the following to subscribe the handset:

Press and hold the key for 3 sec, then press and hold the * key for 3 sec.

The following will appear on the display:

Enter the number of the base unit you would like to subscribe the handset to (1-4)

The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):

Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for the base.

When the handset is registered, it will show ‘HS’ followed by the handset number.

7.2Subscribing a TOPCOM Butler 300 DECT GAP Headset

Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the base unit starts to blink quickly. The line/charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the headset:

Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and green LED will lit ones.

Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover from the headset so that the registration key hole is free also.

Press the headset registration key. The red LED will flash rapidly.

If after a few seconds the green LED flashes slowly, the registration is successful.

If the red LED flashes slowly, the registration is failed. Repeat above procedure.

14

Topcom Butler 3350/Twin/Triple/Quattro

Image 14
Contents Butler 3350/TWIN TRIPLE/QUATTRO Page Caller-ID function Clip Buttons Display InstallationBattery low indication Operation Register/de-register a handsetTopcom Butler Disposal of the device environment Safety InstructionsCleaning Buttons Base InstallationDisplay Multi charger HandsetOutgoing calls Battery low indicationOperation Programming memory numbers Incoming callsActivate/deactivate hands free function Calling a memory numberPaging Setting the volumeSetting the ring volume and melody Flash button RCaller-ID function Clip Setting the dialling modeSetting the ring volume level of the base Key lockRegister/de-register a handset Subscribing a Topcom Butler 300 Dect GAP Headset You only need to subscribe the handset ifCall transfer and conference call during an external call Call transfer and Intercom between two handsetsRemoving a handset Internal call intercomBase Key Functions Answering MachineLED Display & keys are at the bottom of the baseSelect outgoing message Outgoing MessagesRecording outgoing messages OGM 1 or OGM Erasing the Outgoing MessageTurning Answering Machine On/Off Setting number of RingsSetting day and Time Checking number of RingsChanging the VIP Code Checking Day/TimeProgramming the VIP Code Playback of Incoming Messages and Memos OperationRecording a Memo Checking the VIP CodeRemote Operation Erasing MessagesMemory Full Troubleshooting Turning answering machine on remotelyTopcom warranty Technical dataDefault settings Visit our website