Using the Organizer for the First Time
Be sure to perform the following operations before using the Organizer for the first time.
1. Press the RESET switch while holding down ON . Release the RESET switch and then release ON .
“CLEAR ALL DATA OK (Y/N) ?” is displayed.
•Under certain conditions the message may appear as “Data has been impaired ! Press [Y] to CLEAR ALL memory”. Proceed to the next step in either case.
2.Press Y .
3.The Organizer is now initialized. Proceed to set the date and time of the clock. (Refer to page 5.)
Press the RESET switch with a
When Abnormal Conditions Cause a Malfunction
If the Organizer is subjected to strong, extraneous electrical noises or shocks during use, an abnormal condition may occur in which no keys (including ON and OFF ) will respond. If this happens, press the RESET
switch. Noises or shocks may erase some or all of the Organizer’s memory.
Auto Power Off Function
When none of the keys has been pressed for approximately 7 minutes, the Organizer automatically turns the power off to save the batteries. (The actual time may vary depending upon the condition of use.) Press ON to resume operation.
Backlight
The Backlight allows you to view the display and use the Organizer even in
• To turn the Backlight off, press BackLight again.
•The Backlight may remain on for less than the set interval or it may not function if the battery level is very low.
•The Backlight does not function during data transfer.
★Do not use the Backlight unnecessarily.
•Since the Backlight drains power from the operating batteries, excessive use of the Backlight will significantly reduce the life of your batteries.
•Do not continue using the Organizer after it has automatically turned itself off while the backlight was being used. Even if it can be turned on again, the clock time will be incorrect and other functions may not work properly until the batteries are replaced.
Setting up the Backlight
You can change the interval after which the Backlight turns off automatically.
1. | Press | MENU |
| PREV |
| PREV | 4 to select “4: BACKLIGHT SETUP”. | |||
2. | Press | 1 , 2 , | 3 or | 4 to select the |
|
| ||||
TURN | OFF AFTER: | |||||||||
| interval (15 – 60 seconds). | 1: | 15 | SECONDS | ||||||
|
|
|
|
|
|
|
| 2: | 30 | SECONDS |
|
|
|
|
|
|
|
| 3: | 45 | SECONDS |
|
|
|
|
|
|
|
| 4: | 60 | SECONDS |
1