VTech TM3111-2, DS3111-2, DS3111-4, DS3111-3 Important safety instructions

Page 51

Important safety instructions

When using your telephone equipment, basic safety precautions should always be followed:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.

4.Do not use this product near water (for example, near a bathtub, kitchen sink, or swimming pool).

5.Do not place this product on an unstable surface such as a table, shelf or stand. This product may fall, causing serious damage.

6.Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation. To protect them from overheating, these openings must not be blocked by placing the product on a soft surface such as a bed, sofa or rug. This product should never be placed near or over a radiator or heat register. This product should not be placed in an area where proper ventilation is not provided.

7.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply in your home, consult your dealer or local power company.

8.Do not allow anything to rest on the power cord. Do not install this product where the cord may be walked on.

9.Never push objects of any kind into this product through slots in the telephone base or handset as they may touch dangerous voltage points or create a short circuit that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

10.To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening or removing parts of the telephone base or handset other than specified access doors may expose you to dangerous voltages or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.

11.Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.

12.Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions:

A.When the power supply cord or plug is damaged or frayed.

B.If liquid has been spilled onto the product.

C.If the product has been exposed to rain or water.

D.If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operation instructions, as improper adjustment of other controls may result in damage and often requires extensive work by an authorized technician to restore the product to normal operation.

E.If the product has been dropped and the telephone base and/or handset has been damaged.

F.If the product exhibits a distinct change in performance.

13.The power unit is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.

14.Avoid using a telephone (other than cordless) during an electrical storm. There is a remote risk of electric shock from lightning.

15.Do not use the telephone to report a gas leak in the vicinity of the leak.

16.Only put the handset of your telephone next to your ear when it is in normal talk mode.

CAUTION: Use only the power adapter provided with this product. To purchase, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial 1 (800) 267-7377.

SAVE THESE INSTRUCTIONS

48

www.vtechphones.com

Image 51
Contents Congratulations Table of contents Table of contents Parts checklist InstallationCabinet outlet Telephone base & charger installationTelephone line cord Battery installation Charge light Battery chargingAdding a new handset To register a handset to your telephone baseREGISTERED. To Troubleshooting section on To de-register all handsets Replacing a handsetBelt clip & headset optional HeadsetBelt clip Voicemail REDIAL/PAUSE Handset layoutMENU/SELECT Skip CID caller ID page 28 PlayFind Handset Telephone base layoutRinger TONE, the sample of ringer tone will not be heard Telephone settingsRinger volume Ringer toneKey tone LanguageConfirmation tone Clear voicemail Voicemail setup Telephone settingsBasic operationTelephone settings Mute Basic operationMake, answer and end calls SpeakerphoneMultiple handset use VolumeCall waiting Ringer muteVoicemail Answer an incoming call during an intercom call IntercomFLASH, OFF/ Clear or INT Transfer an external callSwitch between external and internal calls Not Available AT this Time will be displayed Advanced operationDirectory Store a directory entryCharacter chart Search the directory Press MENU/SELECT, and the screen displays Edit Number Advanced operation Handset XX Missed Calls Vtech Available AT this Time Saved Already Saved Unable to Save Call log display screen messages Display Means Redial Handset display screen messages Incoming Outside NEW Handset indicatorsUSE Telephone base indicators & charger indicatorBattery Problem Suggestion TroubleshootingLow Battery is Light on the telephone base or charger should be on Tone before dialing For this to take place Service company charges may apply Troubleshooting Numbers I need to To synchronize Important safety instructions Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC, Acta and IC regulations FCC PartFCC Part 68 and Acta Industry Canada Rbrc SealTechnical specifications Index Index 91-001410-080-100 User’s manual