VTech DS3111-3, DS3111-2, DS3111-4, TM3111-2 important safety instructions To synchronize

Page 50

Troubleshooting

Problem

Suggestion

 

 

My cordless handset

• Make sure the power cord is securely plugged into the telephone base. Plug the unit into a

beeps and is not

different working electrical outlet not controlled by a wall switch.

performing normally.

• Move the cordless handset closer to the telephone base. It may be out of range.

 

• Reset the telephone base by unplugging the unit’s electrical power. Wait for 15 seconds and

 

plug it back in again. Allow up to one minute for the cordless handset and the telephone base

 

to synchronize.

 

• Other electronic products can cause interference to your cordless telephone. Try installing

 

your telephone as far away from these electronic devices as possible: wireless routers, radios,

 

radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal

 

computers, kitchen appliances and other cordless telephones.

 

 

Common cure for

• If the unit is not responding normally, try putting the cordless handset in the telephone base or

electronic equipment.

the charger. If it does not seem to respond, try the following (in the order listed):

 

• Disconnect the power to the telephone base.

 

• Disconnect the battery from the cordless handset.

 

• Wait a few minutes before connecting power to the telephone base.

 

Re-install the battery and place the cordless handset into the telephone base or charger.

 

• Wait for the cordless handset to synchronize its connection with the telephone base. Allow up

 

to one minute for this to take place.

 

 

www.vtechphones.com

47

Appendix

Image 50
Contents Congratulations Table of contents Table of contents Installation Parts checklistTelephone base & charger installation Cabinet outletTelephone line cord Battery installation Battery charging Charge lightREGISTERED. To Adding a new handsetTo register a handset to your telephone base Troubleshooting section on Replacing a handset To de-register all handsetsBelt clip Belt clip & headset optionalHeadset CID caller ID page 28 Play Handset layoutMENU/SELECT Skip Voicemail REDIAL/PAUSETelephone base layout Find HandsetRinger tone Telephone settingsRinger volume Ringer TONE, the sample of ringer tone will not be heardConfirmation tone Key toneLanguage Clear voicemail Telephone settingsBasic operation Voicemail setupTelephone settings Speakerphone Basic operationMake, answer and end calls MuteRinger mute VolumeCall waiting Multiple handset useVoicemail Intercom Answer an incoming call during an intercom callTransfer an external call FLASH, OFF/ Clear or INTSwitch between external and internal calls Store a directory entry Advanced operationDirectory Not Available AT this Time will be displayedCharacter chart Search the directory Press MENU/SELECT, and the screen displays Edit Number Advanced operation Handset XX Missed Calls Vtech Available AT this Time Saved Already Saved Unable to Save Call log display screen messages Display Means Redial Handset display screen messages Incoming Outside Handset indicators NEWTelephone base indicators & charger indicator USEBattery Troubleshooting Problem SuggestionLow Battery is Light on the telephone base or charger should be on Tone before dialing For this to take place Service company charges may apply Troubleshooting Numbers I need to To synchronize Important safety instructions Maintenance Operating rangeWarranty About cordless telephonesHow do you get warranty service? FCC Part 68 and Acta FCC, Acta and IC regulationsFCC Part Rbrc Seal Industry CanadaTechnical specifications Index Index 91-001410-080-100 User’s manual