VTech v 2656 FCC, Acta and IC Regulations, VTech Communications Inc, FCC Part

Page 41

FCC, ACTA and IC Regulations

This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

A label is located on the underside of the Base Unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this information to your local telephone company.

This equipment is compatible with inductively coupled hearing aids.

Should you experience trouble with this telephone equipment, please contact:

VTech Communications Inc.

CUSTOMER SERVICE at 1-800-595-9511. In Canada, call VTech Telecommunications Canada Ltd. at 1-800-267-7377.

For repair/warranty information, the telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

To comply with FCC RF exposure requirements, the Base Unit should be installed with its antenna located at 5 cm or more from persons.

41

Additional Information

91-005358-050-000 v2656.pmd

41

8/5/2004, 4:51 PM

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Important Safety Instructions Vtech Communications INC Introduction StopParts Check List Handset Layout Base Unit Layout Connecting Power to Base Unit SetupInstallation of Battery Pack in Handset Connecting to phone line Charging Of Handset Battery PackChecking for dial tone Case of DifficultyWall Mounting Registration of Additional Handsets Registration and Operation of the v 2600 Accessory HandsetSetup of the v 2600 Accessory Handset Found Base Enter Base ID CodeHandset Icons Handset and Base IndicatorsBase Leds Icon DescriptionCaller ID Call Waiting ID Soft Menu FunctionsRDL Redial See To Edit a Number/Name, on Calls Log Caller IDLOW Batt Tone preset to on Handset SettingsRange Tone preset to on Keypad Tone preset to onRange Extender preset to Auto Tone/Pulse Selection preset to ToneRange EXTENDER, then press OK Range Extender menuMemory Register and MemorySave To Store a Number/NameSearch For and Dial a Number To Search For and Dial a Number NameTo Delete a Number/Name To Edit a Number/Name Making Calls Handset and Base OperationAnswering Calls Mute FunctionFrom Base to ALL Handsets Volume ControlFlash Function Use Indication Switching between the Handset Earpiece and SpeakerphoneHandsfree Speakerphone Operation Transferring Calls Low Battery IndicationConference Calling Answering System Operation Audible IndicatorsAnswering System Operation Turn Answering System On or OffAbout Announcements About MailboxesRecord Your Announcement AnsweringSystemOperationTo delete your announcement Answering System Feature SetupTo review your announcement Set Security Code Default setting indicated bySet Audible Message Alert OffListen to Messages Press Volume or Volume Adjust Playback VolumeDelete Messages Delete a Specific Message Delete All Old Messages in a MailboxCall Screening Record a Memo99, flashing Counting 1 toSteady for one second 40-99Voice Menu Remote AccessBelt Clip Headset OperationMaintenance Case Of Difficulty Handset Does Not Ring When You Receive a CallPhone Doesnt Work At All No Dial ToneCommon Cure For Electronic Equipment You Hear Other Calls While Using Your PhoneYour Answering System is not recording messages CL is flashing on the Base UnitWhat does this limited warranty cover? Warranty StatementHow long is the limited warranty period? What is not covered by this limited warranty?Other Limitations How do you get warranty service?FCC Part FCC, Acta and IC RegulationsVTech Communications Inc Rights of the telephone company FCC and Acta InformationRepair instructions IC Industry Canada Programming/testing of emergency numbersHearing aid compatibility Rbrc R Seal Nominal Effective Range Technical SpecificationsGetting Started Table Of Contents Important Safety InstructionsBasic Operation Advanced OperationIssue
Top Page Image Contents