Advanced Operation
Handset and Base Operation
From Handset to Handset:
•Press the INTERCOM key followed by the number of the other Handset you wish to call (e.g. INTERCOM 3).
•Handset 3 can then answer the intercom call by pressing the
INTERCOM key.
•To end the intercom call press OFF on either Handset.
NOTE: If only one Handset is registered, the LCD will display "Feature Not Available" when INTERCOM key is pressed.
Global Page
•Press INTERCOM. Then scroll down to GLOBAL PAGE. Press OK.
•Any Handset can answer by pressing INTERCOM.
•To end the intercom call press OFF on Handset.
Handsfree Speakerphone Operation
Your v 2656 Handset has a
HANDSET AND BASE OPERATION.
Switching between the Handset Earpiece and Speakerphone
If you are using the Handset earpiece, press SPEAKER to continue your call using the Handset Speakerphone.
To return to the earpiece, press SPEAKER again.
In Use Indication
On the Handset:
When the telephone line is currently being used by a v 2656 Handset, a status message similar to this will display on idle Handset(s):
When the telephone line is currently being used by a parallel set (a telephone device other than the v 2656 on the same line); the phone icon will remain on steadily, and EXTENSION IN USE will be displayed.
On the Base:
When the telephone line is currently being used by a v 2656 Handset, the IN USE LED on the Base will illuminate steadily.
When the telephone line is currently being used by a parallel set (a telephone device other than the v 2656 on the same line), the IN USE LED on the Base will flash.
When the answering system answers a call, the IN USE LED on the Base will flash, too.
24
24 | 8/5/2004, 4:51 PM |