VTech VT 1421 Technical Specifications, Specifications are typical and may change without notice

Page 31

TECHNICAL SPECIFICATIONS

FREQUENCY CONTROLL

Crystal Controlled Dual PLL Synthesizer

TRANSMIT FREQUENCY

Handset : 925.05 MHz to 927.75 MHz (all ten channels within this range)

Base : 902.3 MHz to 905.0 MHz (all ten channels within this range)

RECEIVE FREQUENCY

Handset : 902.3 MHz to 905.0 MHz (all ten channels within this range)

Base : 925.05 MHz to 927.75 MHz (all ten channels within this range)

NOMINAL EFFECTIVE RANGE

Actual operating range may vary according to environmental conditions at the tine of use.

SIZE

Handset : 150 x 60 x 35mm

Base : 166 x 122 x 116mm (with wall mount) 157 x 113 x 116mm (without wall mount)

WEIGHT

Handset : 145g

Base : 320g (with wall mount) 290g (without wall mount)

POWER REQUIREMENTS

Handset : Self-contained nickel- cadmium rechargeable battery supply.

Base : 9VDC, 300 mA

MEMORY

Speed Dial : 20 memory locations 20 digits per location

Caller ID : Alphanumeric display 50 memory locations

Specifications are typical and may change without notice.

31

Image 31
Contents Introduction Special Features Parts Checklist Hearing Aid Compatibility FCC RegulationsFCC Part FCC Regulations Readandunderstandallinstructions Important Safety InstructionsImportant Safety Instructions Word about Rechargeable Batteries Battery PackCharging the Handset Battery Pack To Charge the Battery PackTo Replace the Handset Battery Pack Replacing a Drained Handset Battery Spare Battery ChargerInstallation Power Backup FunctionGetting Started If not, see in Case of Difficulty Connect Telephone Line CordWall Mounting Handset Layout Base Unit Layout Key / Handset locator Base Unit FeaturesHandset Menu Operation On Hook Stage Quick Reference GuideOff Hook Stage Ending a Call SetupMaking Calls Answering CallsDeleting Speed Dial Memory Dialing From MemoryCaller ID Using RedialReceiving And Storing Calls Caller IDCall Waiting Caller ID Type Word About Caller IDDialing From Caller ID Memory Reviewing Caller ID MemoryDigit Dialing Deleting Call ID Memory Special Message IndicatorsCaller ID Temporary Tone Advanced FunctionsCall Waiting Message WaitingExtension In Use Indication Ear Piece Volume AdjustmentHeadset Jack Set Ring Volume Setup Mode OptionsSet Ring Type Keyclick Selection Dial Type SelectionMaintenance HOW do I Send MY UNIT, in or OUT of WARRANTY? WarrantySpecifications are typical and may change without notice Technical SpecificationsTable of Contents Page Issue