VTech VT 1421 manual Wall Mounting

Page 13

WALL MOUNTING

The Wall Mounting bracket is designed to fit on standard Wall Mounting plates.

1.Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base. A wall switch should not control the outlet. If the switch is ever turned off, your phone may not function (unless you have a fully charged battery in the spare battery charger).

2.Position the wall-mounting bracket on the base. Line up the tabs on the wall-mounting bracket with the holes on the bottom of the base. Snap the wall-mounting bracket firmly in place.

3.Mount the base on the wall. Position the base so the mounting studs will fit into the holes on the wall-mounting bracket. Slide the base down on the mounting studs until it locks into place

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end. Insert one end into the jack on the back of the base, and insert the other end of the plug into the wall jack.

5.Plug the AC adapter into an electrical outlet and the DC connector into the power jack located on the back of the base unit.

13

Image 13

Contents Introduction Special Features Parts Checklist Hearing Aid Compatibility FCC RegulationsFCC Part FCC Regulations Readandunderstandallinstructions Important Safety InstructionsImportant Safety Instructions Charging the Handset Battery Pack Battery PackTo Charge the Battery Pack Word about Rechargeable BatteriesTo Replace the Handset Battery Pack Installation Spare Battery ChargerPower Backup Function Replacing a Drained Handset BatteryGetting Started If not, see in Case of Difficulty Connect Telephone Line CordWall Mounting Handset Layout Base Unit Layout Key / Handset locator Base Unit FeaturesHandset Menu Operation On Hook Stage Quick Reference GuideOff Hook Stage Making Calls SetupAnswering Calls Ending a CallDeleting Speed Dial Memory Dialing From MemoryCaller ID Using RedialCall Waiting Caller ID Type Caller IDWord About Caller ID Receiving And Storing CallsDialing From Caller ID Memory Reviewing Caller ID MemoryDigit Dialing Deleting Call ID Memory Special Message IndicatorsCaller ID Call Waiting Advanced FunctionsMessage Waiting Temporary ToneExtension In Use Indication Ear Piece Volume AdjustmentHeadset Jack Set Ring Volume Setup Mode OptionsSet Ring Type Keyclick Selection Dial Type SelectionMaintenance HOW do I Send MY UNIT, in or OUT of WARRANTY? WarrantySpecifications are typical and may change without notice Technical SpecificationsTable of Contents Page Issue