AT&T BCM50 manual Media Gateway Port Ranges

Page 25

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

4.5 Port Ranges

Configuration Æ Resources Æ Telephony Resources:

Select “Port Ranges” and use the values shown below. The default RTP ranges are from 28000 to 28255. This range is used for fax (T.38), digital phones and analog phones. The media gateway port ranges are configurable.

Figure 18: Media Gateway Port Ranges

The BCM50 IP phone’s RTP and RTCP port range are 51000-51399. Each IP phone call uses two ports. The default port range for RTP and RTCP are not configurable.

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 25 of 37

Image 25

Contents AT&T Voip Table of Contents Table of Figures Customer Questions IntroductionDocument Feedback Document Change History Trouble ReportingIssue Special Notes Emergency 911/E911 Services LimitationsCalling Number Restricted / Private not supported BCM Soft Phones not currently supportedPST OverviewIssue Pstn Nortel BCM50 Version and Feature Requirements Configuration GuideBCM50 Lists of Applied Patches IP Trunks Available VoIP Trunks Assigning Line Pool to IP Trunks Issue Configuring General DN Length Configuring Private Received Number Length Assigning a Route for IP Trunks Assign Code to Access IP Trunk Routes Failover to Secondary AT&T IP Border Element Ipbe SIP Proxy ParametersOutbound Proxy Table for failover to secondary AT&T IPBEs Payload Size Media ParametersConfiguring analog DNs for fax Media Gateway Port Ranges Port RangesConfigurationÆ TelephonyÆ Sets Æ All DNs Configuring Outgoing Calls from BCM50 to AT&T IP Flex ReachConfiguring did for Incoming Calls Configuring Incoming Calls from AT&T IP Flex Reach to BCM50ConfigurationÆ TelephonyÆ Lines Æ Target Lines Assign Line Pool to IP Sets System Monitoring with BCM Monitor TroubleshootingIP Device Listing RTP Session Information System Resources AdministrationÆ General ÆAlarms Real-time display of BCM50 AlarmsLog Management Log ManagementConfiguring Destination Code with Wildcard Appendix a Configuring Destination Code with WildcardEnd of Document