AT&T manual Configuring Outgoing Calls from BCM50 to AT&T IP Flex Reach

Page 26

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

4.6 Configuring Outgoing Calls from BCM50 to AT&T IP Flex Reach

ConfigurationÆ TelephonyÆ Sets Æ All DNs:

We will now associate the private DN number with the DID number. In the example below; 2000 is entered in the “Private OLI” field and 7323683478 is entered in the “Public OLI” field. This example enables “calling number translation” (outgoing) for this particular DN number. See figure below.

Figure 19: Configuring DID for Outgoing Calls

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 26 of 37

Image 26

Contents AT&T Voip Table of Contents Table of Figures Introduction Customer QuestionsTrouble Reporting Document Feedback Document Change HistoryIssue Calling Number Restricted / Private not supported Emergency 911/E911 Services LimitationsSpecial Notes BCM Soft Phones not currently supportedOverview PSTIssue Pstn Configuration Guide Nortel BCM50 Version and Feature RequirementsBCM50 Lists of Applied Patches IP Trunks Available VoIP Trunks Assigning Line Pool to IP Trunks Issue Configuring General DN Length Configuring Private Received Number Length Assigning a Route for IP Trunks Assign Code to Access IP Trunk Routes SIP Proxy Parameters Failover to Secondary AT&T IP Border Element IpbeOutbound Proxy Table for failover to secondary AT&T IPBEs Media Parameters Payload SizeConfiguring analog DNs for fax Port Ranges Media Gateway Port RangesConfiguring Outgoing Calls from BCM50 to AT&T IP Flex Reach ConfigurationÆ TelephonyÆ Sets Æ All DNsConfiguring Incoming Calls from AT&T IP Flex Reach to BCM50 Configuring did for Incoming CallsConfigurationÆ TelephonyÆ Lines Æ Target Lines Assign Line Pool to IP Sets Troubleshooting System Monitoring with BCM MonitorIP Device Listing RTP Session Information System Resources Real-time display of BCM50 Alarms AdministrationÆ General ÆAlarmsLog Management Log ManagementAppendix a Configuring Destination Code with Wildcard Configuring Destination Code with WildcardEnd of Document