AT&T BCM50 manual RTP Session Information

Page 32

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

Figure 25: RTP Session Information

The BCM Monitor can be used to monitor incoming and outgoing trunks to determine if trunks are being busy or if they are idle. The example below depicts utilized lines used by local and remote telephone/DN numbers.

Figure 26: Line Monitor Information

The BCM Monitor can also be used to monitor all types of system usages. The following are some parameters that can be monitored:

•CPU utilization

•Physical memory

•Media card DSP utilization

•IP sets and IP Trunks

•Voice ports and media gateway usage

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 32 of 37

Image 32

Contents AT&T Voip Table of Contents Table of Figures Introduction Customer QuestionsTrouble Reporting Document Feedback Document Change HistoryIssue Emergency 911/E911 Services Limitations Special NotesCalling Number Restricted / Private not supported BCM Soft Phones not currently supportedOverview PSTIssue Pstn Configuration Guide Nortel BCM50 Version and Feature RequirementsBCM50 Lists of Applied Patches IP Trunks Available VoIP Trunks Assigning Line Pool to IP Trunks Issue Configuring General DN Length Configuring Private Received Number Length Assigning a Route for IP Trunks Assign Code to Access IP Trunk Routes SIP Proxy Parameters Failover to Secondary AT&T IP Border Element IpbeOutbound Proxy Table for failover to secondary AT&T IPBEs Media Parameters Payload SizeConfiguring analog DNs for fax Port Ranges Media Gateway Port RangesConfiguring Outgoing Calls from BCM50 to AT&T IP Flex Reach ConfigurationÆ TelephonyÆ Sets Æ All DNsConfiguring Incoming Calls from AT&T IP Flex Reach to BCM50 Configuring did for Incoming CallsConfigurationÆ TelephonyÆ Lines Æ Target Lines Assign Line Pool to IP Sets Troubleshooting System Monitoring with BCM MonitorIP Device Listing RTP Session Information System Resources Real-time display of BCM50 Alarms AdministrationÆ General ÆAlarmsLog Management Log ManagementAppendix a Configuring Destination Code with Wildcard Configuring Destination Code with WildcardEnd of Document