Table of Figures

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

TABLE OF FIGURES
Figure 1: AT&T IP Flexible Reach Network	8
Figure 2: BCM50 Software Version Number	11
Figure 3: BCM50 Lists of Applied Patches	12
Figure 4: Available VoIP Trunks	14
Figure 5: Application Resource availability of SIP (or IP) Trunks	14
Figure 6: Assigning Line Pool to IP Trunks	15
Figure 7: Assigning DN to Line Pool	15
Figure 8: Configuring General DN Length	17
Figure 9: Configuring Public Received Number Length and Dialing Plan	17
Figure 10: Configuring Private Received Number Length	18
Figure 11: Assigning a Route for IP Trunks	19
Figure 12: Assign Code to Access IP Trunk Routes	20
Figure 13: Selecting IP Trunk Module	21
Figure 14: Sip Proxy Parameters	21
Figure 15: Outbound Proxy Table for failover to secondary AT&T IPBEs	22
Figure 16: SIP Media Parameters	23
Figure 17: Configuring analog DNs for fax	24
Figure 18: Media Gateway Port Ranges	25
Figure 19: Configuring DID for Outgoing Calls	26
Figure 20: Configuring DID for Incoming Calls	27
Figure 21: Display DID on IP Set LCD	28
Figure 22: Assign Line Pool to IP Sets	29
Figure 23: System Monitoring Example	30
Figure 24: IP Device Listing	31
Figure 25: RTP Session Information	32
Figure 26: Line Monitor Information	32
Figure 27: System Resources	33
Figure 28: BCM50 Alarms Page	34
Figure 29: Log Management	35
Figure 30: Configuring Destination Code with Wildcard	36

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 3 of 37