AT&T BCM50 manual SIP Proxy Parameters, Failover to Secondary AT&T IP Border Element Ipbe

Page 21

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

4.3 SIP Proxy Parameters

Under Configuration Æ Resources Æ Telephony Resources: Select module type “IP Trunks” and click on the “Sip Proxy” tab (see figures below). Populate the “Domain” as the IP address of the AT&T IP Border Element.

Figure 13: Selecting IP Trunk Module

Figure 14: Sip Proxy Parameters

4.3.1 Failover to Secondary AT&T IP Border Element (IPBE)

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 21 of 37

Image 21

Contents AT&T Voip Table of Contents Table of Figures Customer Questions IntroductionDocument Feedback Document Change History Trouble ReportingIssue Special Notes Emergency 911/E911 Services LimitationsCalling Number Restricted / Private not supported BCM Soft Phones not currently supportedPST OverviewIssue Pstn Nortel BCM50 Version and Feature Requirements Configuration GuideBCM50 Lists of Applied Patches IP Trunks Available VoIP Trunks Assigning Line Pool to IP Trunks Issue Configuring General DN Length Configuring Private Received Number Length Assigning a Route for IP Trunks Assign Code to Access IP Trunk Routes Failover to Secondary AT&T IP Border Element Ipbe SIP Proxy ParametersOutbound Proxy Table for failover to secondary AT&T IPBEs Payload Size Media ParametersConfiguring analog DNs for fax Media Gateway Port Ranges Port RangesConfigurationÆ TelephonyÆ Sets Æ All DNs Configuring Outgoing Calls from BCM50 to AT&T IP Flex ReachConfiguring did for Incoming Calls Configuring Incoming Calls from AT&T IP Flex Reach to BCM50ConfigurationÆ TelephonyÆ Lines Æ Target Lines Assign Line Pool to IP Sets System Monitoring with BCM Monitor TroubleshootingIP Device Listing RTP Session Information System Resources AdministrationÆ General ÆAlarms Real-time display of BCM50 AlarmsLog Management Log ManagementConfiguring Destination Code with Wildcard Appendix a Configuring Destination Code with WildcardEnd of Document