AT&T BCM50 manual IP Device Listing

Page 31

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

The BCM Monitor application can be downloaded to an administrator’s PC from the BCM and pointed at a specific BCM’s IP address for monitoring. Multiple instances of the BCM Monitor application can be used on a single PC to monitor several remote BCM systems at the same time.

Backward version compatibility is supported.

All of the registered IP devices can be viewed with the BCM Monitor. The screen shot below depicts IP Phone type, DN number and IP address of each registered IP phone. Additionally, if the device is active on a call the RTP session information is also displayed.

Figure 24: IP Device Listing

The end-to-end RTP sessions per IP call can also be displayed with the BCM Monitor. The example below depicts an end-to-end call.

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7

Page 31 of 37

Image 31

Contents AT&T Voip Table of Contents Table of Figures Customer Questions IntroductionDocument Feedback Document Change History Trouble ReportingIssue BCM Soft Phones not currently supported Emergency 911/E911 Services LimitationsSpecial Notes Calling Number Restricted / Private not supportedPST OverviewIssue Pstn Nortel BCM50 Version and Feature Requirements Configuration GuideBCM50 Lists of Applied Patches IP Trunks Available VoIP Trunks Assigning Line Pool to IP Trunks Issue Configuring General DN Length Configuring Private Received Number Length Assigning a Route for IP Trunks Assign Code to Access IP Trunk Routes Failover to Secondary AT&T IP Border Element Ipbe SIP Proxy ParametersOutbound Proxy Table for failover to secondary AT&T IPBEs Payload Size Media ParametersConfiguring analog DNs for fax Media Gateway Port Ranges Port RangesConfigurationÆ TelephonyÆ Sets Æ All DNs Configuring Outgoing Calls from BCM50 to AT&T IP Flex ReachConfiguring did for Incoming Calls Configuring Incoming Calls from AT&T IP Flex Reach to BCM50ConfigurationÆ TelephonyÆ Lines Æ Target Lines Assign Line Pool to IP Sets System Monitoring with BCM Monitor TroubleshootingIP Device Listing RTP Session Information System Resources AdministrationÆ General ÆAlarms Real-time display of BCM50 AlarmsLog Management Log ManagementConfiguring Destination Code with Wildcard Appendix a Configuring Destination Code with WildcardEnd of Document