Cisco Systems 6945 manual End a Call, Establish/End a Conference Call, Hold/Resume a Call

Operating Your Phone

End a Call

If your phone supports auto-pickup, you are connected to the call.

If the call rings, press the Answer soft key to connect to the call.

End a Call

•Hang up the handset.

•If you are using a headset, press the Headset button or the EndCall soft key.

•If you are using a speakerphone, press the Speaker button or the EndCall soft key.

Establish/End a Conference Call

Your system administrator must configure the system for a three-party or eight-party ad-hoc conference.

Procedure

Step 1 During a call, press the Conference button to open a new line and put the first party on hold. Step 2 Place a call to another number.

Step 3 Press Conference button again to add the new party to the call.

Step 4 Perform any of the following steps to end a conference call:

•Hang up the handset, or press the Cancel soft key.

•Depending on the configuration, when the conference call initiator disconnects, the conference call terminates.

•To end the conference and remain connected to the most recent call, press the Conf soft key. The older call is placed on hold.

Hold/Resume a Call

Procedure

Step 1 Press the Hold button.

Step 2 Press the Resume soft key or the flashing green line button to resume the call.

Step 3 If your phone supports multiple lines, you can use line buttons to swap between holding and active calls.

Example:

Cisco Unified IP Phone 6945 User Guide for Cisco Unified Communications Manager Express Version 8.8 (SCCP)

OL-24413-01 19