AT&T TL9228, TL9278 Manual connection, Turning off the auto connection, Replace a paired device

Bluetooth

Bluetooth setup

Manual connection

To manually re-connect a paired device, make sure the Bluetooth feature is turned on in your cellular phone, select AT&T DECT 6.0 from the paired device list in your cellular phone. Once the connection is established again, the Bluetooth button on the telephone base will turn back on.

Turning off the auto connection

If you do not want the telephone base to re-connect to a paired device automatically after it is disconnected, you can turn off the auto connection feature manually. While a paired device is connected to the telephone base, enter the paired device list in the cellular phone and disconnect the device from the telephone base; refer to the user's manual of your cellular phone for instructions. The telephone base will not search and re-connect to that paired device until this feature is activated again.

To resume the auto connection between the paired device and the telephone base, make sure the Bluetooth feature is turned on in your cellular phone, select AT&T DECT 6.0 from the paired device list in your cellular phone. The auto connection will then be established again.

Replace a paired device

If you want to pair and connect a new device when there is already a device paired with the telephone base, press and hold the Bluetooth button on the telephone base until it is flashing, then start with step two of Pairing a device on page 19. If you do not pair a new device within two minutes, the Bluetooth light on the telephone base will turn off and the system will return to idle mode.

20