Answering system
NOTES:
1.If a valid remote access code is not entered, the call will be ended automatically.
2.If you pause for more than four seconds during remote access, you
will hear a help menu listing all features and commands. If there is no command for another 20 seconds, the call will end automatically.
3.If you want to delete all the old messages remotely, press 3 twice in remote standby mode.
4.If the memory is full, the answering system will answer after 10 rings and announce, "Memory is full. Enter the remote access code." Enter your remote access code to access the messages and announcements.
Remote access
You can access your answering system remotely by dialing your home telephone number from any
To remotely access your answering system:
1.Dial your telephone number from any touch- tone telephone.
2.When the system answers, enter the two digit remote access code (19 is the default code, see page 62 to change it).
•The system will automatically announce the number of messages (new and/or old)
if there are any, and then begin to play them.
3.You can also enter the following remote commands.
Remote commands
1 Press to listen to all messages.
2 Press to hear only new messages.
3 Press to delete the current message (during playback).
33 Press twice to delete all old messages.
4 Press to repeat the current message (during playback).
44 Press twice to listen to the previous message.
5 Press to stop any operation (including recording).
*5 Press to listen to a list of remote commands.
6 Press to skip to the next message (during playback).
*7 Press to record a new announcement.
0 Press to turn the answering system on or off.
68