AT&T 2256 user manual If you hear noise or interference when using the phone

Page 58

TELEPHONE OPERATION

PROBLEM

If you hear a triple-beep signal when you try to use the handset:

SOLUTION

The handset and base are not communicating properly. You might be out of range. Move closer to the base and try again.

PROBLEM

If you hear noise or interference when using the phone:

SOLUTION

•You may be out of range. Move closer to the base.

•Household appliances plugged into the same circuit as the base can sometimes cause interference. Try moving the appliance or the base to another outlet.

•The layout of your home or office may be limiting the operating range. Try moving the base to another location, preferably on an upper floor.

•Using the handset near household appliances (microwaves,computers, televisions,stereos,etc.) can sometimes cause interference. Move away from appliances while using the handset.

PROBLEM

If the phone does not ring when you receive a call:

SOLUTION

•Make sure the ringer is on.

•Make sure the telephone line cord is connected firmly to the base and the telephone jack.

•Make sure the AC adapter is plugged firmly into an electrical outlet not controlled by a wall switch.

•You might be too far from the base; move closer.

•You might have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of them.

55

Image 58

Contents With Caller ID/Call Waiting Part 1 Important Product InformationPage Contents Parts List Before YOU BeginAbout Caller Identification Caller ID About the Call LogTable/Desk Installation InstallationCharging Stand Installation Connect the power cordCharge the handset battery Install the handset batteryCheck for dial tone Belt Clip HeadsetWall Installation Telephone Feature Setup Feature Setup MenuRing Volume Ring Pattern Key Click Handset Name StepsLanguage Setting Clear Message Waiting Set Dial Method Idle Screen Handset VolumeTelephone Operation Make a CallCall Timer SpeakerphoneFlash/Call Waiting RedialMute Page/Handset Locator Temporary Tone DialingDisplay Screen Messages Screen Displays WhenDisplay Screen Icons This Icon IndicatesBase Lights Light Status IndicatesOne double beep Tones and What They MeanThree quick beeps Two double beepsIntercom Operation Intercom CallsAnswer an Incoming Call While on an Intercom Call Transfer a CallForward a Call Conference Calling Phonebook Store a Number and Name in Phone BookDial Page Dial a Number in Phone Book Edit a Number/Name in Phone Book Page Delete a Number/Name from Phone Book Page Caller ID Operation Review Call Log Remove Call Records Removing a Specific Call RecordRemove All Call Records Store a Call Record in Phone Book Display Dial Dialing OptionsTurn Answering System On or Off Audible IndicatorsAnswering System Operation AT the Base Set the ClockAbout Mailboxes About AnnouncementsRecord Your Announcement To review your announcement at any timeAnswering System Feature Setup Change announce only Feature SummaryChange message alert Change base ringerListen to Messages Adjust Playback Volume Delete MessagesRecord a Memo Message Window Display Window Displays To IndicateConnect with the Answering System Remote AccessRemote Access Commands Voice MenuRecord memo End remote access callRecord announcement Turn system offCharge the Handset Battery Pack Battery LifeBatteries Replace the Handset Battery Pack If the phone does not work at all, check these items first Case of DifficultyTelephone Operation If you haveIf you hear noise or interference when using the phone If the phone does not ring when you receive a callMisdials Caller IDIf your telephone If the caller’s name or phone number is not displayedIf messages are Answering SystemIncomplete If appears Message windowAnnouncement isn’t If your outgoingClear Announce Only Default SettingsDefault Settings Number of RingsTechnical Specifications Technical SpecificationsIndex NEW